#Carvewright card reader series

Please Contact CarveWright Message Bit Not Touching the Bit Plate Carving Edge Shifts in the Y Direction Carving Gets Shallower Going Side to Side Carving Increases in Depth Carving of an Imported Image is Very Rough Clicking Sound Heard During Homing or Carving Cut Motor Changes Speed in the Middle of the Project Cut Motor Not Spinning LHR Technologies, Inc. 9 Error Loading Size: 28 Message Please Clear Board Sensor Message Please Close Cover Message Please Load Bit Message Please Load Board Message Please Set Sliding Plate Message Possible Board Problem Message Possible Board Removal Message Power Fluctuation Message SRAM Message Stuck Compression Roller Message System Error (81). CarveWright Troubleshooting Guide (Rev 1.07) 05/10/11 1Дў Troubleshooting Guide Board Too Thick to Cut Message. Also note that the issues listed below are compiled from all machine configurations from the beginning of production and many of them will not apply to your machine configuration.

Any repair to your CompuCarve or CarveWright machine must be at the direction of a trained CarveWright service technician in order to satisfy all warranty conditions. It is not a repair guide and should not be treated as such.

#Carvewright card reader series

1 Troubleshooting Guide For A, B and C Series CarveWright and CompuCarve Machines Please note that this guide has been generated to help users identify machine issues and diagnose certain common causes.